CONFIG_I2C_SS_SDA_HOLD

(No prompt – not directly user assignable.)

Type: int

Help

The hold time on the data signal after a negative edge of i2c clock. The unit is i2c module base clock.

Direct dependencies

(I2C_QMSI_SS && I2C && SOC_QUARK_SE_C1000_SS) || (I2C_QMSI_SS && I2C)

(Includes any dependencies from if’s and menus.)

Defaults

Kconfig definitions

At soc/arc/quark_se_c1000_ss/Kconfig.defconfig:118

Included via Kconfig:10Kconfig.zephyr:23

Menu path: (top menu)

config I2C_SS_SDA_HOLD
    int
    default 10 if I2C_QMSI_SS && I2C && SOC_QUARK_SE_C1000_SS
    depends on I2C_QMSI_SS && I2C && SOC_QUARK_SE_C1000_SS

At drivers/i2c/Kconfig.qmsi:58

Included via Kconfig:10Kconfig.zephyr:35drivers/Kconfig:40drivers/i2c/Kconfig:26

Menu path: (top menu) → Device Drivers → I2C Drivers → QMSI I2C driver for the Sensor Subsystem

config I2C_SS_SDA_HOLD
    int
    depends on I2C_QMSI_SS && I2C
    help
      The hold time on the data signal after a negative edge of i2c clock.
      The unit is i2c module base clock.

(Definitions include propagated dependencies, including from if’s and menus.)