CONFIG_ETH_POLL_ACTIVE_PERIOD_MS

Receive polling period when transfer is running (ms)

Type: int

Help

This option sets time in milliseconds between two consecutive RTT read attempts when input transfer is running. When transfer stopped some time ago driver will use ETH_POLL_PERIOD_MS again.

Direct dependencies

ETH_RTT && HAS_SEGGER_RTT

(Includes any dependencies from if’s and menus.)

Defaults

Kconfig definition

At ../nrf/drivers/net/Kconfig:88

Included via Kconfig:10Kconfig.zephyr:10/jenkins_workspace/workspace/connect-nrf_documentation_master/_build/Kconfig.modules:1/jenkins_workspace/workspace/connect-nrf_documentation_master/ncs/nrf/Kconfig.nrf:11../nrf/drivers/Kconfig:12

Menu path: (top menu) → Nordic nRF Connect → Device Drivers → Ethernet over RTT driver

config ETH_POLL_ACTIVE_PERIOD_MS
    int
    prompt "Receive polling period when transfer is running (ms)" if ETH_RTT && HAS_SEGGER_RTT
    range 1 ETH_POLL_PERIOD_MS if ETH_RTT && HAS_SEGGER_RTT
    default 5 if ETH_RTT && HAS_SEGGER_RTT
    depends on ETH_RTT && HAS_SEGGER_RTT
    help
      This option sets time in milliseconds between two consecutive RTT
      read attempts when input transfer is running. When transfer stopped
      some time ago driver will use ETH_POLL_PERIOD_MS again.

(Definitions include propagated dependencies, including from if’s and menus.)