CONFIG_DISK_FLASH_ERASE_ALIGNMENT

Flash device erase alignment in hex

Type: hex

Help

This is the start address alignment required by the flash component.

Direct dependencies

(DISK_ACCESS_FLASH && SOC_FLASH_NIOS2_QSPI && FLASH && BOARD_ALTERA_MAX10) || (DISK_ACCESS_FLASH && SPI_FLASH_W25QXXDV && FLASH && SPI && BOARD_ARDUINO_101) || DISK_ACCESS_FLASH

(Includes any dependencies from if’s and menus.)

Kconfig definitions

At boards/nios2/altera_max10/Kconfig.defconfig:32

Included via Kconfig:10Kconfig.zephyr:21

Menu path: (top menu)

config DISK_FLASH_ERASE_ALIGNMENT
    hex
    default 0x10000 if DISK_ACCESS_FLASH && SOC_FLASH_NIOS2_QSPI && FLASH && BOARD_ALTERA_MAX10
    depends on DISK_ACCESS_FLASH && SOC_FLASH_NIOS2_QSPI && FLASH && BOARD_ALTERA_MAX10

At boards/x86/arduino_101/Kconfig.defconfig:41

Included via Kconfig:10Kconfig.zephyr:21

Menu path: (top menu)

config DISK_FLASH_ERASE_ALIGNMENT
    hex
    default 0x1000 if DISK_ACCESS_FLASH && SPI_FLASH_W25QXXDV && FLASH && SPI && BOARD_ARDUINO_101
    depends on DISK_ACCESS_FLASH && SPI_FLASH_W25QXXDV && FLASH && SPI && BOARD_ARDUINO_101

At subsys/disk/Kconfig:87

Included via Kconfig:10Kconfig.zephyr:39subsys/Kconfig:16

Menu path: (top menu) → Disk

config DISK_FLASH_ERASE_ALIGNMENT
    hex
    prompt "Flash device erase alignment in hex" if DISK_ACCESS_FLASH
    depends on DISK_ACCESS_FLASH
    help
      This is the start address alignment required by
      the flash component.

(Definitions include propagated dependencies, including from if’s and menus.)