Zephyr API Documentation  3.6.99
A Scalable Open Source RTOS
Loading...
Searching...
No Matches
gpio.h
Go to the documentation of this file.
1/*
2 * Copyright (c) 2019 Piotr Mienkowski
3 * Copyright (c) 2018 Linaro Limited
4 *
5 * SPDX-License-Identifier: Apache-2.0
6 */
7#ifndef ZEPHYR_INCLUDE_DT_BINDINGS_GPIO_GPIO_H_
8#define ZEPHYR_INCLUDE_DT_BINDINGS_GPIO_GPIO_H_
9
18#define GPIO_DT_FLAGS_MASK 0x3F
19
26#define GPIO_ACTIVE_LOW (1 << 0)
28#define GPIO_ACTIVE_HIGH (0 << 0)
29
39/* Configures GPIO output in single-ended mode (open drain or open source). */
40#define GPIO_SINGLE_ENDED (1 << 1)
41/* Configures GPIO output in push-pull mode */
42#define GPIO_PUSH_PULL (0 << 1)
43
44/* Indicates single ended open drain mode (wired AND). */
45#define GPIO_LINE_OPEN_DRAIN (1 << 2)
46/* Indicates single ended open source mode (wired OR). */
47#define GPIO_LINE_OPEN_SOURCE (0 << 2)
48
57#define GPIO_OPEN_DRAIN (GPIO_SINGLE_ENDED | GPIO_LINE_OPEN_DRAIN)
65#define GPIO_OPEN_SOURCE (GPIO_SINGLE_ENDED | GPIO_LINE_OPEN_SOURCE)
66
75#define GPIO_PULL_UP (1 << 4)
76
78#define GPIO_PULL_DOWN (1 << 5)
79
82/* Note: Bits 15 downto 8 are reserved for SoC specific flags. */
83
87#define GPIO_INT_WAKEUP (1 << 28)
88
93#endif /* ZEPHYR_INCLUDE_DT_BINDINGS_GPIO_GPIO_H_ */