cirque,pinnacle (on i2c bus)

Vendor: Cirque Corporation

Description

Cirque Pinnacle 1CA027 ASIC trackpad connected through I2C

Properties

Properties not inherited from the base binding file.

Name

Type

Details

supply-gpios

phandle-array

 
GPIO specifier that controls power to the device.

This property should be provided when the device has a dedicated
switch that controls power to the device.  The supply state is
entirely the responsibility of the device driver.

Contrast with vin-supply.

vin-supply

phandle

 
Reference to the regulator that controls power to the device.
The referenced devicetree node must have a regulator compatible.

This property should be provided when device power is supplied
by a shared regulator.  The supply state is dependent on the
request status of all devices fed by the regulator.

Contrast with supply-gpios.  If both properties are provided
then the regulator must be requested before the supply GPIOS is
set to an active state, and the supply GPIOS must be set to an
inactive state before releasing the regulator.

data-ready-gpios

phandle-array

 
Data Ready (DR) GPIO pin. The DR pin is connected to Pinnacle HW_DR
which is active high when SW_DR or SW_CC are asserted. If connected
directly, the MCU pin should be configured as active low.

sensitivity

string

 
ADC attenuation, 1x is the most sensitive and 4x is the least sensitive.

Default value: 4x

Legal values: '1x', '2x', '3x', '4x'

data-mode

string

 
Data output mode in which position is reported. In the relative mode
each position is reported as relative to the last position. In the
absolute mode absolute coordinates are reported.

Default value: relative

Legal values: 'absolute', 'relative'

idle-packets-count

int

 
The number of empty packets where both X and Y are set to 0. They are
started to be sent when a finger presence is detected missing (no touch
detected) every 10 ms. They are stopped to be sent when a finger presence
it detected. An application can count these packets in order to detect
taps. When set to 0, no empty packets are sent. Supported values from 0
to 255.

clipping-enable

boolean

 
In the absolute mode enable clipping of reported coordinates which are
outside of the active range.

active-range-x-min

int

 
The minimum X value which can be reported.

Default value: 128

active-range-x-max

int

 
The maximum X value which can be reported.

Default value: 1920

active-range-y-min

int

 
The minimum Y value which can be reported.

Default value: 64

active-range-y-max

int

 
The maximum Y value which can be reported.

Default value: 1472

scaling-enable

boolean

 
In the absolute mode enable scaling of coordinates according to
the specified resolution for X and Y axises. The scaling is applied only
when the clipping is enabled.

scaling-x-resolution

int

 
Resolution for the X axis.

Default value: 1024

scaling-y-resolution

int

 
Resolution for the Y axis.

Default value: 1024

invert-x

boolean

 
In the absolute mode invert X coordinate.

invert-y

boolean

 
In the absolute mode invert Y coordinate.

primary-tap-enable

boolean

 
In the relative mode enable the primary tap.

swap-xy

boolean

 
In the relative mode swap X and Y coordinates. This is equivalent for
rotating coordinates by 90 degrees.