[INFINEON PSoC 62S4 Pioneer Kit]

Overview

The PSOC 62S4 Pioneer kit has a CY8C62x4 MCU, which is an ultra-low-power PSoC device specifically designed for battery-operated analog sensing applications. It includes a 150-MHz Arm® Cortex®-M4 CPU as the primary application processor, a 100-MHz Arm® Cortex®-M0+ CPU that supports low-power operations, up to 256 KB Flash and 128 KB SRAM, programmable analog sensing, CapSense™ touch-sensing, and programmable digital peripherals.

The board features an onboard programmer/debugger (KitProg3), a 512-Mbit Quad SPI NOR flash, a micro-B connector for USB device interface, a thermistor, an ambient light sensor, a 5-segment CapSense™ slider, two CapSense™ buttons, two user LEDs, and a push button. The board supports operating voltages from 1.8 V to 3.3 V for PSoC™ 6 MCU.

Board Name

Board Name (Credit: <owner>)

Hardware

CY8CKIT 062S4 Pioneer Kit Website CY8CKIT 062S4 Pioneer Kit Guide CY8CKIT 062S4 Pioneer Kit Schematic CY8CKIT 062S4 Pioneer Kit Technical Reference Manual CY8CKIT 062S4 Pioneer Kit Datasheet

Supported Features

The board configuration supports the following hardware features:

Interface

Controller

Driver/Component

NVIC

on-chip

nested vectored interrupt controller

SYSTICK

on-chip

system clock

PINCTRL

on-chip

pin control

UART

on-chip

serial port-polling;

The default configuration can be found in the Kconfig boards/infineon/cy8ckit_062s4/cy8ckit_062s4_defconfig.

Clock Configuration

Clock

Source

Output Frequency

FLL

IMO

100.0 MHz

PLL

IMO

48.0 MHz

CLK_HF0

CLK_PATH0

100.0 MHz

Fetch Binary Blobs

west blobs fetch hal_infineon

Build and flash hello world sample

cd zephyr/samples/hello_world
west build -p auto -b cy8ckit_062s4 --pristine
west flash
picocom /dev/ttyACM0 -b 115200

OpenOCD Installation

To get the OpenOCD package, it is required that you

  1. Download the software ModusToolbox 3.1. https://softwaretools.infineon.com/tools/com.ifx.tb.tool.modustoolbox

  2. Once downloaded add the path to access the Scripts folder provided by ModusToolbox export PATH=$PATH:/path/to/ModusToolbox/tools_3.1/openocd/scripts

  3. Add the OpenOCD executable file’s path to west flash/debug.

  4. Flash using: west flash –openocd path/to/infineon/openocd/bin/openocd

  5. Debug using: west debug –openocd path/to/infineon/openocd/bin/openocd

References