nrfxlib API 2.7.99
Loading...
Searching...
No Matches

◆ nrf_802154_trx_receive_frame()

void nrf_802154_trx_receive_frame ( uint8_t  bcc,
nrf_802154_trx_ramp_up_trigger_mode_t  rampup_trigg_mode,
nrf_802154_trx_receive_notifications_t  notifications_mask,
const nrf_802154_fal_tx_power_split_t *  p_ack_tx_power 
)

Puts the trx module into receive frame mode.

The frame will be received into buffer set by nrf_802154_trx_receive_buffer_set.

When in nrf_802154_trx_receive_frame_received, the TIMER is running allowing sending response (e.g. ACK frame) in time regime by a call to nrf_802154_trx_transmit_after_frame_received.

Note
To receive ACK use nrf_802154_trx_receive_ack
Parameters
[in]bccNumber of received bytes after which nrf_802154_trx_receive_frame_bcmatched will be called.
[in]rampup_trigg_modeRadio ramp up triggering mode to be used. If TRX_RAMP_UP_SW_TRIGGER is selected, this function will trigger radio ramp up in a software manner and the caller is guaranteed that ramp up is ongoing when the function ends. If TRX_RAMP_UP_HW_TRIGGER is selected, this function will prepare the operation but it will end without starting radio ramp up. In this case, it is assumed that the trigger will be generated on the (D)PPI channel specified by nrf_802154_trx_ramp_up_ppi_channel_get. It is the user's responsibility to prepare the stimulation of this (D)PPI.
[in]notifications_maskSelects additional notifications generated during a frame reception. It is bitwise combination of nrf_802154_trx_receive_notifications_t values.
[in]p_ack_tx_powerSelects the power which should be used to transmitted an ACK if required.