sdc_hci_cmd_vs_cis_subevent_length_set()

uint8_t sdc_hci_cmd_vs_cis_subevent_length_set

(

const sdc_hci_cmd_vs_cis_subevent_length_set_t *

p_params

)

#include <softdevice_controller/include/sdc_hci_vs.h>

Set the CIS subevent length in microseconds.

This command sets the subevent length to be used for CISes in microseconds. If the configured subevent length is too small, the HCI command used to configure the CIG will fail. If this parameter is set to zero, the subevent length is chosen by the controller.

The default value is 0. That is, the minimum required subevent length will be used.

This API must be called before creating a CIG.

The configured value is retained after issuing an HCI Reset command.

Event(s) generated (unless masked away): When the command has completed, an HCI_Command_Complete event shall be generated.

Parameters

[in]

p_params

Input parameters.

Return values

0	if success.

Returns

Returns value between 0x01-0xFF in case of error. See Vol 2, Part D, Error for a list of error codes and descriptions.