sdc_hci_cmd_le_set_data_length()

uint8_t sdc_hci_cmd_le_set_data_length	(	const sdc_hci_cmd_le_set_data_length_t *	p_params,
		sdc_hci_cmd_le_set_data_length_return_t *	p_return
	)

#include <softdevice_controller/include/sdc_hci_cmd_le.h>

LE Set Data Length.

The description below is extracted from Core_v5.4, Vol 4, Part E, Section 7.8.33

The HCI_LE_Set_Data_Length command allows the Host to suggest the maximum transmission payload size and maximum packet transmission time (connMaxTxOctets and connMaxTxTime - see [Vol 6] Part B, Section 4.5.10) to be used for LL Data PDUs on a given connection. The Controller may use smaller or larger values based on local information.

Event(s) generated (unless masked away): When the HCI_LE_Set_Data_Length command has completed, an HCI_Command_Complete event shall be generated.

If the command causes the maximum transmission packet size or maximum packet transmission time to change, an HCI_LE_Data_Length_Change event shall be generated.

Parameters

[in]	p_params	Input parameters.
[out]	p_return	Extra return parameters.

Return values

0	if success.

Returns

Returns value between 0x01-0xFF in case of error. See Vol 2, Part D, Error for a list of error codes and descriptions.