sdc_hci_cmd_le_set_host_channel_classification()

uint8_t sdc_hci_cmd_le_set_host_channel_classification

(

const sdc_hci_cmd_le_set_host_channel_classification_t *

p_params

)

#include <softdevice_controller/include/sdc_hci_cmd_le.h>

LE Set Host Channel Classification.

The description below is extracted from Core_v5.4, Vol 4, Part E, Section 7.8.19

The HCI_LE_Set_Host_Channel_Classification command allows the Host to specify a channel classification for the data, secondary advertising, periodic, and isochronous physical channels based on its “local information”. This classification persists until overwritten with a subsequent HCI_LE_Set_Host_Channel_Classification command or until the Controller is reset using the HCI_Reset command (see [Vol 6] Part B, Section 4.5.8.1).

If this command is used, the Host should send it within 10 seconds of knowing that the channel classification has changed. The interval between two successive commands sent shall be at least one second.

Event(s) generated (unless masked away): When the HCI_LE_Set_Host_Channel_Classification command has completed, an HCI_Command_Complete event shall be generated.

Parameters

[in]

p_params

Input parameters.

Return values

0	if success.

Returns

Returns value between 0x01-0xFF in case of error. See Vol 2, Part D, Error for a list of error codes and descriptions.