 |
nrfxlib API 2.7.99
|
|
nrfxlib API 2.7.99
|
| uint8_t sdc_hci_cmd_cb_set_controller_to_host_flow_control | ( | const sdc_hci_cmd_cb_set_controller_to_host_flow_control_t * | p_params | ) |
#include <softdevice_controller/include/sdc_hci_cmd_controller_baseband.h>
Set Controller To Host Flow Control.
The description below is extracted from Core_v5.4, Vol 4, Part E, Section 7.3.38
This command is used by the Host to turn flow control on or off for data and/or voice sent in the direction from the Controller to the Host. If flow control is turned off, the Host should not send the HCI_Host_Number_Of_Completed_Packets command. That command will be ignored by the Controller if it is sent by the Host and flow control is off. If flow control is turned on for HCI ACL Data packets and off for HCI Synchronous Data packets, HCI_Host_Number_Of_Completed_- Packets commands sent by the Host should only contain Connection_Handles for ACL connections. If flow control is turned off for HCI ACL Data packets and on for HCI Synchronous Data packets, HCI_Host_Number_Of_Completed_- Packets commands sent by the Host should only contain Connection_Handles for synchronous connections. If flow control is turned on for HCI ACL Data packets and HCI Synchronous Data packets, the Host will send HCI_Host_- Number_Of_Completed_Packets commands both for ACL connections and synchronous connections.
The Flow_Control_Enable parameter shall only be changed if no connections exist.
Event(s) generated (unless masked away): When the HCI_Set_Controller_To_Host_Flow_Control command has completed, an HCI_Command_Complete event shall be generated.
| [in] | p_params | Input parameters. |
| 0 | if success. |
1.9.6