sdc_hci_cmd_le_remove_adv_set()

uint8_t sdc_hci_cmd_le_remove_adv_set

(

const sdc_hci_cmd_le_remove_adv_set_t *

p_params

)

#include <softdevice_controller/include/sdc_hci_cmd_le.h>

LE Remove Advertising Set.

The description below is extracted from Core_v5.4, Vol 4, Part E, Section 7.8.59

The HCI_LE_Remove_Advertising_Set command is used to remove an advertising set from the Controller.

If the advertising set corresponding to the Advertising_Handle parameter does not exist, then the Controller shall return the error code Unknown Advertising Identifier (0x42). If advertising or periodic advertising on the advertising set is enabled, then the Controller shall return the error code Command Disallowed (0x0C).

Event(s) generated (unless masked away): When the HCI_LE_Remove_Advertising_Set command has completed, an HCI_Command_Complete event shall be generated.

Parameters

[in]

p_params

Input parameters.

Return values

0	if success.

Returns

Returns value between 0x01-0xFF in case of error. See Vol 2, Part D, Error for a list of error codes and descriptions.