sdc_hci_cmd_le_periodic_adv_terminate_sync()

uint8_t sdc_hci_cmd_le_periodic_adv_terminate_sync

(

const sdc_hci_cmd_le_periodic_adv_terminate_sync_t *

p_params

)

#include <softdevice_controller/include/sdc_hci_cmd_le.h>

LE Periodic Advertising Terminate Sync.

The description below is extracted from Core_v5.4, Vol 4, Part E, Section 7.8.69

The HCI_LE_Periodic_Advertising_Terminate_Sync command is used to stop reception of the periodic advertising train identified by the Sync_Handle parameter.

If the periodic advertising train corresponding to the Sync_Handle parameter does not exist, then the Controller shall return the error code Unknown Advertising Identifier (0x42).

Following successful completion of this command the Sync_Handle is destroyed.

Event(s) generated (unless masked away): When the HCI_LE_Periodic_Advertising_Terminate_Sync command has completed, an HCI_Command_Complete event shall be generated.

Parameters

[in]

p_params

Input parameters.

Return values

0	if success.

Returns

Returns value between 0x01-0xFF in case of error. See Vol 2, Part D, Error for a list of error codes and descriptions.