sdc_hci_cmd_le_periodic_adv_sync_transfer()

uint8_t sdc_hci_cmd_le_periodic_adv_sync_transfer	(	const sdc_hci_cmd_le_periodic_adv_sync_transfer_t *	p_params,
		sdc_hci_cmd_le_periodic_adv_sync_transfer_return_t *	p_return
	)

#include <softdevice_controller/include/sdc_hci_cmd_le.h>

LE Periodic Advertising Sync Transfer.

The description below is extracted from Core_v5.4, Vol 4, Part E, Section 7.8.89

The HCI_LE_Periodic_Advertising_Sync_Transfer command is used to instruct the Controller to send synchronization information about the periodic advertising train identified by the Sync_Handle parameter to a connected device.

The Service_Data parameter is a value provided by the Host for use by the Host of the peer device. It is not used by the Controller.

The connected device is identified by the Connection_Handle parameter.

If the periodic advertising train corresponding to the Sync_Handle parameter does not exist, the Controller shall return the error code Unknown Advertising Identifier (0x42).

If the Connection_Handle parameter does not identify a current connection, the Controller shall return the error code Unknown Connection Identifier (0x02).

If the remote device has not indicated support for the Periodic Advertising Sync Transfer - Recipient feature, the Controller shall return the error code Unsupported Remote Feature (0x1A).

Note: This command may complete before the periodic advertising synchronization information is sent. No indication is given as to how the recipient handled the information.

Event(s) generated (unless masked away): When the HCI_LE_Periodic_Advertising_Sync_Transfer command has completed, an HCI_Command_Complete event shall be generated.

Parameters

[in]	p_params	Input parameters.
[out]	p_return	Extra return parameters.

Return values

0	if success.

Returns

Returns value between 0x01-0xFF in case of error. See Vol 2, Part D, Error for a list of error codes and descriptions.