Network Configuration Library
Overview
The network configuration library sets up networking devices in a semi-automatic way during the system boot, based on user-supplied Kconfig options.
The following Kconfig options affect how configuration library will setup the system:
Option name |
Description |
|---|---|
This option controls whether the network system is configured or initialized at all. If not set, then the config library is not used for initialization and the application needs to do all the network related configuration itself. If this option is set, then the user can optionally configure static IP addresses to be set to the first network interface in the system. Typically setting static IP addresses is only usable in testing and should not be used in production code. See the config library Kconfig file subsys/net/lib/config/Kconfig for specific options to set the static IP addresses. |
|
The networking system is automatically configured when the device is started. |
|
This tells how long to wait for
the networking to be ready and available. If for example IPv4 address from
DHCPv4 is not received within this limit, then a call to
|
|
The network application needs IPv4
support to function properly. This option makes sure the network application
is initialized properly in order to use IPv4.
If |
|
The network application needs IPv6
support to function properly. This option makes sure the network application
is initialized properly in order to use IPv6.
If |
|
If IPv6 is enabled, then this option tells that the network application needs IPv6 router to exists before continuing. This means in practice that the application wants to wait until it receives IPv6 router advertisement message before continuing. |
Sample usage
If CONFIG_NET_CONFIG_AUTO_INIT is set, then the configuration library
is automatically enabled and run during the device boot. In this case,
the library will call net_config_init() automatically and the application
does not need to do any network configuration.
If you want to use the network configuration library but without automatic
initialization, you can call net_config_init() manually. The flags
parameter can be used to give hints to the library about what kind of
functionality the application wishes to have before the actual application
starts.