sdc_hci_cmd_cb_reset()

uint8_t sdc_hci_cmd_cb_reset

(

void

)

#include <softdevice_controller/include/sdc_hci_cmd_controller_baseband.h>

Reset.

The description below is extracted from Core_v5.4, Vol 4, Part E, Section 7.3.2

The HCI_Reset command will reset the Controller and the Link Manager on the BR/EDR Controller or the Link Layer on an LE Controller. If the Controller supports both BR/EDR and LE then the HCI_Reset command shall reset the Link Manager, Baseband and Link Layer. The HCI_Reset command shall not affect the used HCI transport layer since the HCI transport layers may have reset mechanisms of their own. After the reset is completed, the current operational state will be lost, the Controller will enter standby mode and the Controller will automatically revert to the default values for the parameters for which default values are defined in the specification.

Note: The HCI_Reset command will not necessarily perform a hardware reset. This is implementation defined.

The Host shall not send additional HCI commands before the HCI_Command_Complete event related to the HCI_Reset command has been received.

Event(s) generated (unless masked away): When the reset has been performed, an HCI_Command_Complete event shall be generated.

Return values

0	if success.

Returns

Returns value between 0x01-0xFF in case of error. See Vol 2, Part D, Error for a list of error codes and descriptions.