◆ sdc_hci_cmd_le_set_periodic_adv_receive_enable()

uint8_t sdc_hci_cmd_le_set_periodic_adv_receive_enable ( const sdc_hci_cmd_le_set_periodic_adv_receive_enable_t * p_params )

#include <softdevice_controller/include/sdc_hci_cmd_le.h>

LE Set Periodic Advertising Receive Enable.

The description below is extracted from Core_v5.4, Vol 4, Part E, Section 7.8.88

The HCI_LE_Set_Periodic_Advertising_Receive_Enable command will enable or disable reports for the periodic advertising train identified by the Sync_Handle parameter.

The Enable parameter determines whether reporting and duplicate filtering are enabled or disabled. If the value is the same as the current state, the command has no effect.

If the periodic advertising train corresponding to the Sync_Handle parameter does not exist, the Controller shall return the error code Unknown Advertising Identifier (0x42).

If the Host sets both bits 0 and 1 of Enable and the Controller does not support the Periodic Advertising ADI Support feature, then the Controller shall return an error which should use the error code Unsupported Feature or Parameter Value (0x11).

Event(s) generated (unless masked away): When the HCI_LE_Set_Periodic_Advertising_Receive_Enable command has completed, an HCI_Command_Complete event shall be generated.

Parameters

[in] p_params Input parameters.

Return values

0	if success.

Returns: Returns value between 0x01-0xFF in case of error. See Vol 2, Part D, Error for a list of error codes and descriptions.