sdc_hci_cmd_le_set_scan_response_data()

uint8_t sdc_hci_cmd_le_set_scan_response_data

(

const sdc_hci_cmd_le_set_scan_response_data_t *

p_params

)

#include <softdevice_controller/include/sdc_hci_cmd_le.h>

LE Set Scan Response Data.

The description below is extracted from Core_v5.4, Vol 4, Part E, Section 7.8.8

This command is used to provide data used in Scanning Packets that have a data field.

Only the significant part of the Scan_Response_Data should be transmitted in the Scanning Packets, as defined in [Vol 3] Part C, Section 11.

If advertising is currently enabled, the Controller shall use the new data in subsequent advertising events. If an advertising event is in progress when this command is issued, the Controller may use the old or new data for that event. If advertising is currently disabled, the data shall be kept by the Controller and used once advertising is enabled.

The default Scan_Response_Data_Length shall be zero and the default Scan_Response_Data shall be 31 zero octets.

Event(s) generated (unless masked away): When the HCI_LE_Set_Scan_Response_Data command has completed, an HCI_Command_Complete event shall be generated.

Parameters

[in]

p_params

Input parameters.

Return values

0	if success.

Returns

Returns value between 0x01-0xFF in case of error. See Vol 2, Part D, Error for a list of error codes and descriptions.