◆ sdc_hci_cmd_le_add_device_to_periodic_adv_list()

uint8_t sdc_hci_cmd_le_add_device_to_periodic_adv_list ( const sdc_hci_cmd_le_add_device_to_periodic_adv_list_t * p_params )

#include <softdevice_controller/include/sdc_hci_cmd_le.h>

LE Add Device To Periodic Advertiser List.

The description below is extracted from Core_v5.4, Vol 4, Part E, Section 7.8.70

The HCI_LE_Add_Device_To_Periodic_Advertiser_List command is used to add an entry, consisting of a single device address and SID, to the Periodic Advertiser list stored in the Controller. Any additions to the Periodic Advertiser list take effect immediately. If the entry is already on the list, the Controller shall return the error code Invalid HCI Command Parameters (0x12).

If the Host issues this command when an HCI_LE_Periodic_Advertising_- Create_Sync command is pending, the Controller shall return the error code Command Disallowed (0x0C).

When a Controller cannot add an entry to the Periodic Advertiser list because the list is full, the Controller shall return the error code Memory Capacity Exceeded (0x07).

Event(s) generated (unless masked away): When the HCI_LE_Add_Device_To_Periodic_Advertiser_List command has completed, an HCI_Command_Complete event shall be generated.

Parameters

[in] p_params Input parameters.

Return values

0	if success.

Returns: Returns value between 0x01-0xFF in case of error. See Vol 2, Part D, Error for a list of error codes and descriptions.