◆ sdc_hci_cmd_le_set_privacy_mode()

uint8_t sdc_hci_cmd_le_set_privacy_mode ( const sdc_hci_cmd_le_set_privacy_mode_t * p_params )

#include <softdevice_controller/include/sdc_hci_cmd_le.h>

LE Set Privacy Mode.

The description below is extracted from Core_v5.4, Vol 4, Part E, Section 7.8.77

The HCI_LE_Set_Privacy_Mode command is used to allow the Host to specify the privacy mode to be used for a given entry on the resolving list. The effect of this setting is specified in [Vol 6] Part B, Section 4.7.

When an entry on the resolving list is removed, the mode associated with that entry shall also be removed.

This command shall not be used when address resolution is enabled in the Controller and: • Advertising (other than periodic advertising) is enabled, • Scanning is enabled, or • an HCI_LE_Create_Connection, HCI_LE_Extended_Create_Connection, or HCI_LE_Periodic_Advertising_Create_Sync command is pending.

This command may be used at any time when address resolution is disabled in the Controller.

If the device is not on the resolving list, the Controller shall return the error code Unknown Connection Identifier (0x02).

Event(s) generated (unless masked away): When the HCI_LE_Set_Privacy_Mode command has completed, an HCI_Command_Complete event shall be generated.

Parameters

[in] p_params Input parameters.

Return values

0	if success.

Returns: Returns value between 0x01-0xFF in case of error. See Vol 2, Part D, Error for a list of error codes and descriptions.