◆ sdc_hci_cmd_le_set_host_feature()

uint8_t sdc_hci_cmd_le_set_host_feature ( const sdc_hci_cmd_le_set_host_feature_t * p_params )

#include <softdevice_controller/include/sdc_hci_cmd_le.h>

LE Set Host Feature.

The description below is extracted from Core_v5.3, Vol 4, Part E, Section 7.8.115

The HCI_LE_Set_Host_Feature command is used by the Host to set or clear a bit controlled by the Host in the Link Layer FeatureSet stored in the Controller (see [Vol 6] Part B, Section 4.6).

The Bit_Number parameter specifies the bit position in the FeatureSet.

The Bit_Value parameter specifies whether the feature is enabled or disabled.

If Bit_Number specifies a feature bit that is not controlled by the Host, the Controller shall return the error code Unsupported Feature or Parameter Value (0x11).

If Bit_Value is set to 0x01 and Bit_Number specifies a feature bit that requires support of a feature that the Controller does not support, the Controller shall return the error code Unsupported Feature or Parameter Value (0x11).

If the Host issues this command while the Controller has a connection to another device, the Controller shall return the error code Command Disallowed (0x0C).

Event(s) generated (unless masked away): When the HCI_LE_Set_Host_Feature command has completed, an HCI_Command_Complete event shall be generated.

Parameters

[in] p_params Input parameters.

Return values

0	if success.

Returns: Returns value between 0x01-0xFF in case of error. See Vol 2, Part D, Error for a list of error codes and descriptions.