- Generated on Thu Sep 26 2024 10:53:02 for nrfxlib API by
1.9.6
|
nrfxlib API 0.1.0
|
| uint8_t sdc_hci_cmd_le_set_default_periodic_adv_sync_transfer_params | ( | const sdc_hci_cmd_le_set_default_periodic_adv_sync_transfer_params_t * | p_params | ) |
#include <softdevice_controller/include/sdc_hci_cmd_le.h>
LE Set Default Periodic Advertising Sync Transfer Parameters.
The description below is extracted from Core_v5.4, Vol 4, Part E, Section 7.8.92
The HCI_LE_Set_Default_Periodic_Advertising_Sync_Transfer_Parameters command is used to specify the initial value for the mode, skip, timeout, and Constant Tone Extension type (set by the HCI_LE_Set_Periodic_Advertising_- Sync_Transfer_Parameters command; see Section 7.8.91) to be used for all subsequent connections over the LE transport.
The Mode parameter specifies the initial action to be taken. If Mode is 0x00, the Controller will ignore the information. Otherwise it will notify the Host and synchronize to the periodic advertising. Mode also specifies whether periodic advertising reports are initially enabled or disabled and whether duplicates are filtered.
The Skip parameter specifies the number of consecutive periodic advertising packets that the receiver may skip after successfully receiving a periodic advertising packet.
The Sync_Timeout parameter specifies the maximum permitted time between successful receives. If this time is exceeded, synchronization is lost.
The CTE_Type parameter specifies whether to only synchronize to periodic advertising with certain types of Constant Tone Extension. If the periodic advertiser changes the type of the Constant Tone Extension after the Controller has synchronized with the periodic advertising, it shall remain synchronized.
Note: A value of 0 (i.e. all bits clear) indicates that the presence or absence of a Constant Tone Extension is irrelevant.
This command does not affect any existing connection.
If the Host sets Mode to 0x03 and the Controller does not support the Periodic Advertising ADI Support feature, then the Controller shall return an error which should use the error code Unsupported Feature or Parameter Value (0x11).
Event(s) generated (unless masked away): When the HCI_LE_Set_Default_Periodic_Advertising_Sync_Transfer_- Parameters command has completed, an HCI_Command_Complete event shall be generated.
| [in] | p_params | Input parameters. |
| 0 | if success. |
1.9.6