Tracing

This application can be used to demonstrate the tracing feature. The tracing formatted packet will be sent to the host with the currently supported tracing backend under tracing generic infrastructure.

Requirements

Depends of the boards which you are using, choose one of .conf files for use tracing subsys.

Usage for UART Tracing Backend

Build a UART-tracing image with:

west build -b mps2/an521 samples/subsys/tracing -- -DCONF_FILE="prj_uart.conf"

or:

west build -b mps2/an521 samples/subsys/tracing -- -DCONF_FILE="prj_uart_ctf.conf"

Note

You may need to set “zephyr,tracing-uart” property under the chosen node in your devicetree. See boards/mps2_an521.overlay for an example.

After the application has run for a while, check the trace output file.

Usage for USB Tracing Backend

Build a USB-tracing image with:

west build -b sam_e70_xplained/same70q21 samples/subsys/tracing -- -DCONF_FILE="prj_usb.conf"

or:

west build -b sam_e70_xplained/same70q21 samples/subsys/tracing -- -DCONF_FILE="prj_usb_ctf.conf"

After the serial console has stable output like this:

threadA: Hello World!
threadB: Hello World!
threadA: Hello World!
threadB: Hello World!

Connect the board’s USB port to the host device and run the scripts/tracing/trace_capture_usb.py script on the host:

sudo python3 trace_capture_usb.py -v 0x2FE9 -p 0x100 -o channel0_0

The VID and PID of USB device can be configured, just adjusting it accordingly.

Usage for POSIX Tracing Backend

Build a POSIX-tracing image with:

west build -b native_sim samples/subsys/tracing

or:

west build -b native_sim samples/subsys/tracing -- -DCONF_FILE="prj_native_ctf.conf"

After the application has run for a while, check the trace output file.

Usage for USER Tracing Backend

Build a USER-tracing image with:

west build -b qemu_x86 samples/subsys/tracing -- -DCONF_FILE="prj_user.conf"

After the application has run for a while, check the trace output file.