cypress,psoc6-spi

Vendor: Cypress Semiconductor Corporation

Description

These nodes are “spi” bus nodes.

Cypress SBC[SPI]

Properties

Properties not inherited from the base binding file.

Name

Type

Details

clock-frequency

int

 
Clock frequency the SPI peripheral is being driven at, in Hz.

cs-gpios

phandle-array

 
An array of chip select GPIOs to use. Each element
in the array specifies a GPIO. The index in the array
corresponds to the child node that the CS gpio controls.

Example:

  spi@... {
          cs-gpios = <&gpio0 23 GPIO_ACTIVE_LOW>,
                        <&gpio1 10 GPIO_ACTIVE_LOW>,
                        ...;

          spi-device@0 {
                  reg = <0>;
                  ...
          };
          spi-device@1 {
                  reg = <1>;
                  ...
          };
          ...
  };

The child node "spi-device@0" specifies a SPI device with
chip select controller gpio0, pin 23, and devicetree
GPIO flags GPIO_ACTIVE_LOW. Similarly, "spi-device@1" has CS GPIO
controller gpio1, pin 10, and flags GPIO_ACTIVE_LOW. Additional
devices can be configured in the same way.

If unsure about the flags cell, GPIO_ACTIVE_LOW is generally a safe
choice for a typical "CSn" pin. GPIO_ACTIVE_HIGH may be used if
intervening hardware inverts the signal to the peripheral device or
the line itself is active high.

If this property is not defined, no chip select GPIOs are set.
SPI controllers with dedicated CS pins do not need to define
the cs-gpios property.

peripheral-id

int

 
peripheral ID

This property is required.

pinctrl-0

phandles

 
Port pin configuration for the various SPI signals that includes
MISO, MOSI, SCK, and possibly various chip selects signals.  We
expect that the phandles will reference pinctrl nodes.  These
nodes will have a nodelabel that matches the Cypress SoC HAL defines
and be of the form p<port>_<pin>_<periph><inst>_<signal>.

For example the SPI on PSoC-63 Pioneer Kit would be
   pinctrl-0 = <&p12_0_spi6_mosi &p12_1_spi6_miso &p12_2_spi6_clk &p12_3_spi6_sel0>;

This property is required.