INFINEON XMC45-RELAX-KIT
Overview
The XMC4500 Relax Kit is designed to evaluate the capabilities of the XMC4500 Microcontroller. It is based on High performance ARM Cortex-M4F which can run up to 120MHz.
Features:
ARM Cortex-M4F XMC4500
32 Mbit Quad-SPI Flash
4 x SPI-Master, 3x I2C, 3 x I2S, 3 x UART, 2 x CAN, 17 x ADC
2 pin header x1 and x2 with 80 pins
Two buttons and two LEDs for user interaction
Detachable on-board debugger (second XMC4500) with Segger J-Link
Details on the Relax Kit development board can be found in the Relax Kit User Manual.
Supported Features
The on-board 12-MHz crystal allows the device to run at its maximum operating speed of 120MHz.
The Relax Kit development board configuration supports the following hardware features:
Interface |
Controller |
Driver/Component |
|---|---|---|
NVIC |
on-chip |
nested vectored interrupt controller |
SYSTICK |
on-chip |
system clock |
UART |
on-chip |
serial port |
SPI |
on-chip |
spi |
GPIO |
on-chip |
gpio |
FLASH |
on-chip |
flash |
ADC |
on-chip |
adc |
DMA |
on-chip |
dma |
PWM |
on-chip |
pwm |
WATCHDOG |
on-chip |
watchdog |
MDIO |
on-chip |
mdio |
ETHERNET |
on-chip |
ethernet |
PTP |
on-chip |
ethernet |
More details about the supported peripherals are available in XMC4500 TRM Other hardware features are not currently supported by the Zephyr kernel.
Building and Flashing
Flashing
Here is an example for the Hello World application.
# From the root of the zephyr repository
west build -b xmc45_relax_kit samples/hello_world
west flash
Debugging
Here is an example for the Hello World application.
# From the root of the zephyr repository
west build -b xmc45_relax_kit samples/hello_world
west debug
Step through the application in your debugger.