ST Nucleo C031C6

Overview

The STM32 Nucleo-64 development board with STM32C031C6 MCU, supports Arduino and ST morpho connectivity.

The STM32 Nucleo board provides an affordable, and flexible way for users to try out new concepts, and build prototypes with the STM32 microcontroller, choosing from the various combinations of performance, power consumption and features.

The STM32 Nucleo board integrates the ST-LINK/V2-1 debugger and programmer.

The STM32 Nucleo board comes with the STM32 comprehensive software HAL library together with various packaged software examples.

Nucleo C031C6

More information about the board can be found at the Nucleo C031C6 website [1].

Hardware

Nucleo C031C6 provides the following hardware components:

  • STM32 microcontroller in 48-pin package featuring 32 Kbytes of Flash memory and 12 Kbytes of SRAM.

  • Extension resource:

    • Arduino* Uno V3 connectivity

  • On-board ST-LINK/V2-1 debugger/programmer with SWD connector:

  • Flexible board power supply:

    • USB VBUS or external source (3.3V, 5V, 7 - 12V)

    • Current consumption measurement (IDD)

  • Four LEDs:

    • USB communication (LD1), USB power fault LED (LD2), power LED (LD3), user LED (LD4)

  • Two push-button: USER and RESET

  • USB re-enumeration capability. Three different interfaces supported on USB:

    • Virtual COM port

    • Mass storage

    • Debug port

More information about STM32C031C6 can be found here: STM32C0x1 reference manual [2]

Supported Features

The Zephyr nucleo_c031c6 board configuration supports the following hardware features:

Interface

Controller

Driver/Component

NVIC

on-chip

nested vector interrupt controller

UART

on-chip

serial port-polling; serial port-interrupt

PINMUX

on-chip

pinmux

GPIO

on-chip

gpio

CLOCK

on-chip

reset and clock control

RTC

on-chip

counter

IWDG

on-chip

independent watchdog

WWDG

on-chip

window watchdog

PWM

on-chip

pwm

ADC

on-chip

ADC Controller

die-temp

on-chip

die temperature sensor

I2C

on-chip

i2c

DMA

on-chip

Direct Memory Access

Other hardware features are not yet supported in this Zephyr port.

The default configuration can be found in the defconfig file: boards/arm/nucleo_c031c6/nucleo_c031c6_defconfig

Connections and IOs

Each of the GPIO pins can be configured by software as output (push-pull or open-drain), as input (with or without pull-up or pull-down), or as peripheral alternate function. Most of the GPIO pins are shared with digital or analog alternate functions. All GPIOs are high current capable except for analog inputs.

Default Zephyr Peripheral Mapping:

  • UART_2 TX/RX : PA2/PA3 (ST-Link Virtual Port Com)

  • LD4 : PA5

For mode details please refer to STM32 Nucleo-64 board User Manual [3].

Programming and Debugging

Applications for the nucleo_c031c6 board configuration can be built and flashed in the usual way (see Building an Application and Run an Application for more details).

Flashing

Nucleo C031C6 board includes an ST-LINK/V2-1 embedded debug tool interface.

Flashing an application to Nucleo C031C6

Here is an example for the Blinky application.

# From the root of the zephyr repository
west build -b nucleo_c031c6 samples/basic/blinky
west flash

You will see the LED blinking every second.

References