Changelog

Notable changes to this controller are documented in this file.

Controller v3424

The following changes have been introduced in the v3424 of the controller:

Changes

  • Improved robustness of the timestamps (the SDU references) received together with the ISO data.

  • Changed offset of the timestamps (the SDU references) received together with the ISO data to get correct presentation delay.

  • Freed more pins for front-end module (FEM) control.

  • Improved ACL and BIS coexistence on the same device.

  • Fixed an issue where the peripheral did not always accept timing values from the same central.

  • Fixed an issue where the PA sync skip parameter was not used.

  • Fixed an issue where it was not possible to create BIG sync after terminating a pending BIG sync.

Controller v3393

The following changes have been introduced in the v3393 of the controller:

Changes

  • Updated the controller code with major changes that improve performance on many levels.

  • Fixed all failing EBQ tests for claiming the QDID.

  • Fixed an issue where the timing of the TXEN FEM pin was wrong and would cause unwanted radio noise.

  • Fixed timestamps that are returned when using the LE_READ_ISO_TX_SYNC HCI command.

Controller v3357

The following changes have been introduced in the v3357 of the controller:

Changes

  • Updated the controller to be able to read RSSI from the CIS ISO channel using the HCI_Read_RSSI HCI command.

  • Fixed an issue where pins P0.28 to P0.31 cannot be allocated for controlling front-end modules (FEMs).

  • Fixed an issue where the FEM control pins cannot work when the TX output power setting equals 0 dBm.

Controller v3349

The following changes have been introduced in the v3349 of the controller:

Changes

  • Fixed the Direct Test Mode (DTM), which was broken after version 3307.

  • Fixed an issue where an update to the connection parameter could lead to a disconnection.

  • Fixed an issue where the “stream stopped” and “disconnected” events would not be triggered.

  • Fixed an issue where the controller would stop responding when a disconnection happened.

Controller v3330

The following changes have been introduced in the v3330 of the controller:

Changes

  • Fixed issue where resetting one headset caused the other to disconnect.

Controller v3322

The following changes have been introduced in the v3322 of the controller:

Changes

  • Improvements to support creating CIS connections in any order.

  • Changes to accommodate BIS + ACL combinations.

  • Basic support for interleaved broadcasts.

Known issues

See the nRF5340 Audio application known issues for the list of known issues for the controller.

Limitations

The controller is closely related to the nRF5340 Audio application. See the nRF5340 Audio application feature support table for the list of supported features and limitations.