Crypto: ECDSA

The ECDSA sample shows how to sign and verify messages using SHA-256 as the hashing algorithm and the secp256r1 curve.

Requirements

The sample supports the following development kits:

Hardware platforms

PCA

Board name

Build target

nRF9160 DK

PCA10090

nrf9160dk_nrf9160

nrf9160dk_nrf9160_ns nrf9160dk_nrf9160

nRF5340 DK

PCA10095

nrf5340dk_nrf5340

nrf5340dk_nrf5340_cpuapp_ns nrf5340dk_nrf5340_cpuapp

nRF52840 DK

PCA10056

nrf52840dk_nrf52840

nrf52840dk_nrf52840

When built for an _ns build target, the sample is configured to compile and run as a non-secure application. Therefore, it automatically includes Trusted Firmware-M that prepares the required peripherals and secure services to be available for the application.

Overview

The sample performs the following operations:

  1. Initialization:

    1. The Platform Security Architecture (PSA) API is initialized.

    2. A random Elliptic Curve Cryptography (ECC) key pair is generated and imported into the PSA crypto keystore.

    3. The public key of the ECDSA key pair is imported into the PSA crypto keystore.

  2. ECDSA signing and verification:

    1. Signing is performed using the private key of the ECC key pair.

    2. The signature is verified using the exported public key.

  3. Cleanup:

    1. The key pair and public key are removed from the PSA crypto keystore.

Building and running

This sample can be found under samples/crypto/ecdsa in the nRF Connect SDK folder structure.

When built as a non-secure firmware image for the _ns build target, the sample automatically includes the Trusted Firmware-M (TF-M).

See Building and programming an application for information about how to build and program the application and Testing and debugging an application for general information about testing and debugging in the nRF Connect SDK.

Testing

After programming the sample to your development kit, complete the following steps to test it:

  1. Connect to the kit with a terminal emulator (for example, PuTTY). See How to connect with PuTTY for the required settings.

  2. Compile and program the application.

  3. Observe the logs from the application using an RTT Viewer or a terminal emulator.

Note

By default, the sample is configured to use both RTT and UART for logging. If you are using RTT, skip the first step of the testing procedure.