LP5030/6: 10 or 12 RGB channels
Overview
This sample controls up to 12 LEDs connected to a LP503x driver.
First, for each LED information is retrieved using the led_get_info syscall and printed in the log messages. Next, from an infinite loop, a test pattern (described below) is applied to all the LEDs simultaneously (using the led_write_channels syscall) and then to each LED one by one (using the led_set_{brightness,color} syscalls).
Test pattern
For all the LEDs first (using channel API) and then for each LED one by one:
For each color in red green blue white yellow purple cyan orange:
set the color
turn on
turn off
set the brightness gradually to the maximum level
turn off
Building and Running
This sample can be built and executed on boards with an I2C LP5030/6 LED driver connected. A node matching the “ti,lp503x” binding should be defined in the board DTS files.
As an example this sample provides a DTS overlay for the NXP LPCXpresso11U68
board (boards/lpcxpresso11u68.overlay). It assumes that a I2C LP5030
LED driver (with 10 LEDs wired) is connected to the I2C0 bus at address 0x30.