MDIO
Overview
MDIO is a bus that is commonly used to communicate with ethernet PHY devices. Many ethernet MAC controllers also provide hardware to communicate over MDIO bus with a peripheral device.
This API is intended to be used primarily by PHY drivers but can also be used by user firmware.
API Reference
- group mdio_interface
MDIO Interface.
Functions
-
void mdio_bus_enable(const struct device *dev)
Enable MDIO bus.
- Parameters
dev – [in] Pointer to the device structure for the controller
-
void mdio_bus_disable(const struct device *dev)
Disable MDIO bus and tri-state drivers.
- Parameters
dev – [in] Pointer to the device structure for the controller
-
int mdio_read(const struct device *dev, uint8_t prtad, uint8_t devad, uint16_t *data)
Read from MDIO Bus.
This routine provides a generic interface to perform a read on the MDIO bus.
- Parameters
dev – [in] Pointer to the device structure for the controller
prtad – [in] Port address
devad – [in] Device address
data – Pointer to receive read data
- Return values
0 – If successful.
-EIO – General input / output error.
-ETIMEDOUT – If transaction timedout on the bus
-
int mdio_write(const struct device *dev, uint8_t prtad, uint8_t devad, uint16_t data)
Write to MDIO bus.
This routine provides a generic interface to perform a write on the MDIO bus.
- Parameters
dev – [in] Pointer to the device structure for the controller
prtad – [in] Port address
devad – [in] Device address
data – [in] Data to write
- Return values
0 – If successful.
-EIO – General input / output error.
-ETIMEDOUT – If transaction timedout on the bus
-
void mdio_bus_enable(const struct device *dev)