CONFIG_I2S_SAM_SSC_0_PIN_RF_EN

RF pin enabled

Type: bool

Help

If enabled RF signal is connected to RF pin. It will be configured as
an output or an input depending on whether the receiver is working
in master or slave mode.

If disabled RF signal is disconnected from RF pin and connected
internally to TF (Transmitter Frame Synchro signal).

Direct dependencies

I2S_SAM_SSC && I2S

(Includes any dependencies from ifs and menus.)

Default

y

Kconfig definition

At <Zephyr>/drivers/i2s/Kconfig.sam_ssc:24

Included via <Zephyr>/Kconfig:8 → <Zephyr>/Kconfig.zephyr:42 → <Zephyr>/drivers/Kconfig:44 → <Zephyr>/drivers/i2s/Kconfig:28

Menu path: (Top) → Device Drivers → I2S bus drivers → Atmel SAM MCU family I2S (SSC) Bus Driver

config I2S_SAM_SSC_0_PIN_RF_EN
    bool "RF pin enabled"
    default y
    depends on I2S_SAM_SSC && I2S
    help
      If enabled RF signal is connected to RF pin. It will be configured as
      an output or an input depending on whether the receiver is working
      in master or slave mode.

      If disabled RF signal is disconnected from RF pin and connected
      internally to TF (Transmitter Frame Synchro signal).

(The ‘depends on’ condition includes propagated dependencies from ifs and menus.)