CONFIG_CLOCK_CONTROL_STM32_CUBE

STM32 Reset & Clock Control

Type: bool

Help

Enable driver for Reset & Clock Control subsystem found
in STM32 family of MCUs

Direct dependencies

(CLOCK_CONTROL && SOC_FAMILY_STM32) || (CLOCK_CONTROL && SOC_FAMILY_STM32) || (SOC_FAMILY_STM32 && CLOCK_CONTROL)

(Includes any dependencies from ifs and menus.)

Defaults

y
y

Symbols selected by this symbol

Symbols that select this symbol

Kconfig definitions

At <Zephyr>/soc/arm/st_stm32/common/Kconfig.defconfig.series:24

Included via <Zephyr>/Kconfig:8 → <Zephyr>/Kconfig.zephyr:25 → <nRF>/doc/_build/kconfig/Kconfig.soc.defconfig:1 → <Zephyr>/soc/arm/st_stm32/Kconfig.defconfig:3

Menu path: (Top)

config CLOCK_CONTROL_STM32_CUBE
    bool
    default y
    depends on CLOCK_CONTROL && SOC_FAMILY_STM32

At <Zephyr>/soc/arm/st_stm32/common/Kconfig.defconfig.series:24

Included via <Zephyr>/Kconfig:8 → <Zephyr>/Kconfig.zephyr:27 → <Zephyr>/soc/arm/st_stm32/Kconfig.defconfig:3

Menu path: (Top)

config CLOCK_CONTROL_STM32_CUBE
    bool
    default y
    depends on CLOCK_CONTROL && SOC_FAMILY_STM32

At <Zephyr>/drivers/clock_control/Kconfig.stm32:7

Included via <Zephyr>/Kconfig:8 → <Zephyr>/Kconfig.zephyr:42 → <Zephyr>/drivers/Kconfig:56 → <Zephyr>/drivers/clock_control/Kconfig:31

Menu path: (Top) → Device Drivers → Hardware clock controller support

menuconfig CLOCK_CONTROL_STM32_CUBE
    bool "STM32 Reset & Clock Control"
    select USE_STM32_LL_UTILS
    select USE_STM32_LL_RCC if SOC_SERIES_STM32MP1X
    depends on SOC_FAMILY_STM32 && CLOCK_CONTROL
    help
      Enable driver for Reset & Clock Control subsystem found
      in STM32 family of MCUs

(The ‘depends on’ condition includes propagated dependencies from ifs and menus.)