CONFIG_PINMUX_INIT_PRIORITY

Init priority

Type: int

Help

Pinmux driver initialization priority.
Pinmux driver almost certainly should be initialized before the
rest of hardware devices (which may need specific pins already
configured for them), and usually after generic GPIO drivers.
Thus, its priority should be between KERNEL_INIT_PRIORITY_DEFAULT
and KERNEL_INIT_PRIORITY_DEVICE. There are exceptions to this
rule for particular boards. Don't change this value unless you
know what you are doing.

Direct dependencies

(PINMUX && SOC_SERIES_LPC11U6X) || (PINMUX && SOC_SERIES_LPC11U6X) || PINMUX

(Includes any dependencies from ifs and menus.)

Defaults

• 1

• 1

• 45

Kconfig definitions

At <Zephyr>/soc/arm/nxp_lpc/lpc11u6x/Kconfig.defconfig.series:22

Included via <Zephyr>/Kconfig:8 → <Zephyr>/Kconfig.zephyr:25 → <nRF>/doc/_build/kconfig/Kconfig.soc.defconfig:1 → <Zephyr>/soc/arm/nxp_lpc/Kconfig.defconfig:4

Menu path: (Top)

config PINMUX_INIT_PRIORITY
    int
    default 1
    depends on PINMUX && SOC_SERIES_LPC11U6X

---

At <Zephyr>/soc/arm/nxp_lpc/lpc11u6x/Kconfig.defconfig.series:22

Included via <Zephyr>/Kconfig:8 → <Zephyr>/Kconfig.zephyr:27 → <Zephyr>/soc/arm/nxp_lpc/Kconfig.defconfig:4

Menu path: (Top)

config PINMUX_INIT_PRIORITY
    int
    default 1
    depends on PINMUX && SOC_SERIES_LPC11U6X

---

At <Zephyr>/drivers/pinmux/Kconfig:14

Included via <Zephyr>/Kconfig:8 → <Zephyr>/Kconfig.zephyr:42 → <Zephyr>/drivers/Kconfig:48

Menu path: (Top) → Device Drivers → Enable board pinmux driver

config PINMUX_INIT_PRIORITY
    int "Init priority"
    default 45
    depends on PINMUX
    help
      Pinmux driver initialization priority.
      Pinmux driver almost certainly should be initialized before the
      rest of hardware devices (which may need specific pins already
      configured for them), and usually after generic GPIO drivers.
      Thus, its priority should be between KERNEL_INIT_PRIORITY_DEFAULT
      and KERNEL_INIT_PRIORITY_DEVICE. There are exceptions to this
      rule for particular boards. Don't change this value unless you
      know what you are doing.

(The ‘depends on’ condition includes propagated dependencies from ifs and menus.)