CONFIG_NET_PKT_TXTIME_STATS

Enable network packet TX time statistics

Type: bool

Help

Enable network packet TX time statistics support. This is used to
calculate how long on average it takes for a packet to travel from
application to just before it is sent to network. The TX timing
information can then be seen in network interface statistics in
net-shell.
The RX calculation is done only for UDP, TCP or RAW packets,
but for TX we do not know the protocol so the TX packet timing is
done for all network protocol packets.

Direct dependencies

(NET_UDP || NET_TCP || NET_SOCKETS_PACKET) && NET_NATIVE && NETWORKING

(Includes any dependencies from ifs and menus.)

Defaults

No defaults. Implicitly defaults to n.

Symbols selected by this symbol

Kconfig definition

At <Zephyr>/subsys/net/ip/Kconfig:799

Included via <Zephyr>/Kconfig:8 → <Zephyr>/Kconfig.zephyr:44 → <Zephyr>/subsys/Kconfig:39 → <Zephyr>/subsys/net/Kconfig:83

Menu path: (Top) → Sub Systems and OS Services → Networking → Link layer and IP networking support → IP stack

config NET_PKT_TXTIME_STATS
    bool "Enable network packet TX time statistics"
    select NET_PKT_TIMESTAMP
    select NET_STATISTICS
    depends on (NET_UDP || NET_TCP || NET_SOCKETS_PACKET) && NET_NATIVE && NETWORKING
    help
      Enable network packet TX time statistics support. This is used to
      calculate how long on average it takes for a packet to travel from
      application to just before it is sent to network. The TX timing
      information can then be seen in network interface statistics in
      net-shell.
      The RX calculation is done only for UDP, TCP or RAW packets,
      but for TX we do not know the protocol so the TX packet timing is
      done for all network protocol packets.

(The ‘depends on’ condition includes propagated dependencies from ifs and menus.)