Bluetooth: Direction Finding Periodic Advertising Beacon

Overview

A simple application demonstrating the BLE Direction Finding CTE Broadcaster functionality by sending Constant Tone Extension with periodic advertising PDUs.

Requirements

  • nRF52833DK board with nRF52833 SOC

  • antenna matrix for AoD (optional)

Building and Running

This sample can be found under samples/bluetooth/ direction_finding_connectionless_tx in the Zephyr tree.

By default the application supports Angle of Arrival and Angle of Departure mode.

To use Angle of Arrival mode only, build this application as follows:

west build -b nrf52833dk_nrf52833 samples/bluetooth/direction_finding_connectionless_tx -- -DOVERLAY_CONFIG=overlay-aoa.conf
west flash

See bluetooth samples section for common information about bluetooth samples.

Antenna matrix configuration

To use this sample with Angle of Departure enabled, additional GPIOS configuration is required to enable control of the antenna array. Example of such configuration is provided in samples/bluetooth/direction_finding_connectionless_tx/boards/ nrf52833dk_nrf52833.overlay.

samples/bluetooth/direction_finding_connectionless_tx/boards/ nrf52833dk_nrf52833.overlay is a device tree overlay that provides information about which GPIOS should be used by Radio peripheral to switch between antenna patches during CTE transmission in AoD mode. At least two GPIOs must be provided to enable antenna switching. GPIOS are used by Radio peripheral in order following indices of dfegpio#-gpios properties. The order is important because it affects mapping of antenna switch patterns to GPIOS (see Antenna patterns).

Antenna patterns

The antenna switch pattern is a binary number where each bit is applied to a particular antenna GPIO pin. For example, the pattern 0x3 means that antenna GPIOs at index 0,1 will be set, and following are left unset.

This also means that, for example, when using four GPIOs, the patterns count cannot be greater than 16 and maximum allowed value is 15.

If the number of switch-sample periods is greater than the number of stored switch patterns, then the radio loops back first pattern.

To successfully use Direction Finding Beacon with AoD mode enabled provide following data related with owned antenna matrix design: