Bluetooth LE discovery module

Use the Bluetooth LE discovery module to discover GATT Services and read GATT Attribute Values from an nRF Desktop peripheral. The module is mandatory for the nRF Desktop central.

Module events

Source Module	Input Event	This Module	Output Event	Sink Module
Bluetooth LE advertising module	ble_peer_event	ble_discovery
Bluetooth LE state module
Source modules for module_state_event	module_state_event
Bluetooth LE discovery module	ble_discovery_complete_event
			ble_discovery_complete_event	HID forward module
				Bluetooth LE connection parameters module
				Bluetooth LE scanning module
				Bluetooth LE discovery module
			module_state_event	Sink modules for module_state_event

Note

See the Overview: Firmware architecture for more information about the event-based communication in the nRF Desktop application and about how to read this table.

Configuration

Complete the following steps to configure the module:

1. Complete the basic Bluetooth configuration, as described in Bluetooth in nRF Desktop.

2. Set the CONFIG_BT_GATT_CLIENT Kconfig option to enable support for the GATT Client role.

3. Set the CONFIG_BT_GATT_DM Kconfig option to enable the GATT Discovery Manager. The GATT Discovery Manager is used by the ble_discovery application module.

4. Define the module configuration in the ble_discovery_def.h file, located in the board-specific directory in the application configuration directory. You must define the following parameters for every nRF Desktop peripheral that connects with the given nRF Desktop central:

   • Parameters common for all the peripherals:

     • Vendor ID (VID)

   • Parameters defined separately for every peripheral:

     • Product ID (PID)

     • Peer type (PEER_TYPE_MOUSE or PEER_TYPE_KEYBOARD)

   For an example of the module configuration, see configuration/nrf52840dongle_nrf52840/ble_discovery_def.h.

   Note

   The module configuration example uses 0x1915 as Nordic Semiconductor’s VID. Make sure to change this value to the VID of your company.

   The assigned PIDs should be unique for devices with the same VID.

5. Set the CONFIG_DESKTOP_BLE_DISCOVERY_ENABLE Kconfig option to enable the ble_discovery application module.

Implementation details

The Bluetooth LE discovery module implementation is tasked with peripheral discovery and verification.

Peripheral discovery

The module starts the peripheral device discovery when it receives ble_peer_event with ble_peer_event.state set to PEER_STATE_SECURED.

The peripheral discovery consists of the following steps:

1. Reading device description. The central checks if the connected peripheral supports the LLPM (Low Latency Packet Mode). The device description is a GATT Characteristic that is specific for nRF Desktop peripherals and is implemented by Device description module.

2. Reading HW ID (hardware ID). The hardware ID is unique per device and it is used to identify the device while forwarding the Configuration channel data. The HW ID is a read from a GATT Characteristic that is specific for nRF Desktop peripherals and is implemented by Device description module.

3. Reading DIS (Device Information Service). The central reads VID and PID of the connected peripheral.

4. HIDS (Human Interface Device Service) discovery. The central discovers HIDS and forwards the information to other application modules using ble_discovery_complete event. The HID forward module uses the event to register a new subscriber.

Note

Only one peripheral can be discovered at a time. The nRF Desktop central will not scan for new peripherals if a peripheral discovery is in progress.

Peripheral verification

If the connected peripheral does not provide one of the required GATT Characteristics, the central disconnects. The same actions are taken if the peripheral’s VID and PID value combination is unknown to the central.

The nRF Desktop central works only with predefined subset of peripherals. The mentioned peripherals must be described in the ble_discovery_def.h file.