Help¶

Enable a 6LoCAN Ethernet translator. With this translator it is
possible to connect a 6LoCAN network to a Ethernet network directly,
via a Switch or through a router. Messages that goes through the
translator have a special address and the MAC address is carried inline.
The packet is forwarded with uncompressed IPv6 header.

Direct dependencies¶

NET_L2_ETHERNET && NET_L2_CANBUS && NETWORKING

(Includes any dependencies from ifs and menus.)

Defaults¶

No defaults. Implicitly defaults to n.

Kconfig definition¶

At <Zephyr>/subsys/net/l2/canbus/Kconfig:55

Included via <Zephyr>/Kconfig:8 → <Zephyr>/Kconfig.zephyr:34 → <Zephyr>/subsys/Kconfig:39 → <Zephyr>/subsys/net/Kconfig:85 → <Zephyr>/subsys/net/l2/Kconfig:79

Menu path: (Top) → Sub Systems and OS Services → Networking → Link layer and IP networking support → Link layer options → Enable CANBUS L2 layer [EXPERIMENTAL]

config NET_L2_CANBUS_ETH_TRANSLATOR
    bool "Enable 6LoCAN to Ethernet translator"
    depends on NET_L2_ETHERNET && NET_L2_CANBUS && NETWORKING
    help
      Enable a 6LoCAN Ethernet translator. With this translator it is
      possible to connect a 6LoCAN network to a Ethernet network directly,
      via a Switch or through a router. Messages that goes through the
      translator have a special address and the MAC address is carried inline.
      The packet is forwarded with uncompressed IPv6 header.

(The ‘depends on’ condition includes propagated dependencies from ifs and menus.)