Help¶

Timeout is used in uart_poll_out and uart_fifo_fill (if interrupt driven API is enabled).

Direct dependencies¶

NRF_SW_LPUART

(Includes any dependencies from ifs and menus.)

Default¶

1000

Kconfig definition¶

At <nRF>/drivers/serial/Kconfig:23

Included via <Zephyr>/Kconfig:8 → <Zephyr>/Kconfig.zephyr:9 → <BuildDir>/Kconfig/Kconfig.modules:1 → <nRF>/Kconfig.nrf:27 → <nRF>/drivers/Kconfig:14

Menu path: (Top) → Modules → Nordic nRF Connect → Device Drivers → Low Power UART using REQ/RDY lines

config NRF_SW_LPUART_DEFAULT_TX_TIMEOUT
    int "TX Timeout in milliseconds"
    default 1000
    depends on NRF_SW_LPUART
    help
      Timeout is used in uart_poll_out and uart_fifo_fill (if interrupt
      driven API is enabled).

(The ‘depends on’ condition includes propagated dependencies from ifs and menus.)