Temperature Example

The Temperature Example shows how to use a temperature sensor and print the measurement.

The application starts with configuring the temperature module and app_uart. The main loop reads the temperature sensor and prints measurement every 500 milliseconds.

The name of the example is temperature_pca10028. If you are not using the Keil Pack Installer, you can find the source code and project file of the example in the following folder: <InstallFolder>\examples\peripheral\temperature

Testing

Test the Temperature Example application by performing the following steps:

1. Compile and program the application.
2. Start a COM listener like PUTTY and connect to the used COM port with the following UART settings:
   • Baud rate: 38.400
   • 8 data bits
   • 1 stop bit
   • No parity
   • HW flow control: RTS/CTS
3. Observe that a temperature value is printed every 500 milliseconds.