PWM Example

The PWM Example demonstrates the use of the pulse-width modulation library by generating waveforms over a GPIO. The GPIO pin could drive a small speaker, for example.

This example generates two variable duty cycle pulses using two PWM channels (with positive and negative polarity). The duty cycle is changed automatically and will vary between 0 and 100.

The application will emit light on LED 1 and LED 2, corresponding to the duty cycle. With a higher value, the LED will emit less intense light.

Setup

The name of the example is pwm_pca10028. If you are not using the Keil Pack Installer, you can find the source code and project file of the example in the following folder: <InstallFolder>\examples\peripheral\pwm

LED assignments:

• LED 1 shows the duty cycle of channel 1.
• LED 2 shows the duty cycle of channel 2 (negative polarity).

Testing

Test the PWM Example application by performing the following steps:

1. Compile and program the application.
2. Observe that the LED light intensity changes. LED 1 should give the opposite light intensity compared to LED 2.