nRF51 SDK - S120 SoftDevice
|
The Pin Change Interrupt Example demonstrates interrupts on pin change on pin 0. Pin 8 is configured as output and toggled in the pin change interrupt handler. It uses the hardware delivered in the nRF51822 Development Kit.
The application starts with configuring the pins and configuring GPIOTE to give an interrupt on pin 0 change. The interrupt handler toggles pin 8 (LED 0) when pin 0 (button 0) is pressed.
Instructions on how to set up the nRFgo Motherboard: nRFgo Motherboard Setup (nRF6310).
LED assignments:
Button assignments:
The Pin Change Interrupt Example Application can be tested as follows: