nRF51 SDK - S130 SoftDevice
 All Data Structures Functions Variables Typedefs Enumerations Enumerator Groups Pages
Blood Pressure Application

The Blood Pressure Application is an example that implements the Blood Pressure profile using the hardware delivered in the nRF51 Development Kit.

The application includes the two services in the Blood Pressure profile:

In addition, use of the Battery Service is also demonstrated. When the application starts, a timer for generating battery measurements is started.

When indication of the Blood Pressure Measurement characteristic is enabled, a Blood Pressure Measurement is transmitted. This also happens when reconnecting to a previously bonded central. A Blood Pressure Measurement is also transmitted each time button 1 is pushed.

Note
This application is not power optimized!
The application will stop advertising after 3 minutes and go to system-off mode. Push button 1 or button 2 to wake it up and restart advertising.

Setup

The name of the example is ble_app_bps_s130_pca10028. If you are not using the Keil Pack Installer, you can find the source code and project file of the example in the following folder: <InstallFolder>\examples\ble_peripheral\ble_app_bps

Button assignments - in addition to those defined in BSP BLE Button Assignments:

  • During Connection:
    • Button 1: Simulate and send a Blood Pressure Measurement.

Testing

Test the Blood Pressure Application with the nRF Toolbox app, which is available on both iOS (Apple Store) and Android (Google Play).

You can also test the application with the Master Control Panel by performing the following steps:

  1. Compile and program the application. Observe that the BSP_INDICATE_ADVERTISING state is indicated.
  2. Connect to the device from Master Control Panel (the device will be advertising as 'Nordic_BPS'), then bond and perform service discovery. Observe that the BSP_INDICATE_CONNECTED state is indicated.
  3. Click the 'Enable services' button on the Master Control Panel. Observe that one Blood Pressure Measurement indication is received. Also, Battery Level notifications are received every two seconds.
  4. Click the 'Disconnect' button and then the 'Connect' button on the Master Control Panel. Observe that one Blood Pressure Measurement indication is received.
  5. Push Button 1. Observe that one Blood Pressure Measurement indication is received each time the button is pushed.