sbs,default-sbs-gauge (on i2c bus)

Vendor: Smart Battery System

Description

Default generic smart battery fuel gauge driver. Includes support for battery cutoff if enabled.

This compatible is intended to be used with the abstract SBS Gauge compatible because it is
actuated by the SBS driver for SBS compliant fuel gauge ICs.

Properties

Properties not inherited from the base binding file.

Name

Type

Details

battery-cutoff-reg-addr

int

Address of register to receive cutoff payload for battery cutoff.

battery-cutoff-payload

array

Payload to write to cutoff battery register. This must be array of maximum 2 integers.

Default value: [16, 16]

supply-gpios

phandle-array

GPIO specifier that controls power to the device.

This property should be provided when the device has a dedicated
switch that controls power to the device.  The supply state is
entirely the responsibility of the device driver.

Contrast with vin-supply.

vin-supply

phandle

Reference to the regulator that controls power to the device.
The referenced devicetree node must have a regulator compatible.

This property should be provided when device power is supplied
by a shared regulator.  The supply state is dependent on the
request status of all devices fed by the regulator.

Contrast with supply-gpios.  If both properties are provided
then the regulator must be requested before the supply GPIOS is
set to an active state, and the supply GPIOS must be set to an
inactive state before releasing the regulator.

battery-cutoff-support

boolean

Helper prop that indicates whether this device can cutoff the battery; this is also often
referred to as ship or sleep mode.